Conformity To Standards/ Designations - Pfannenberg Quadro LED-HI-3G/3D Betriebsanleitung

en

5. Conformity to standards/ designations

Conformity to standards:
(Explosion protection)
Designation
PDG 19.0007 X
Special conditions
X: The device is suitable for a low degree of mechanical hazard in accordance with the requirements of EN
60079-0. This means:
➢ The device must be mounted protected against impact.
A protective basket is not absolutely necessary.
Refer to the Safety information
from the housing surface in potentially explosive gas atmospheres:
➢ The device must only be wet-cleaned.
➢ Avoid unintentional and dry rubbing.
An installation height of > 2.50 m or comparable protective measures is therefore suggested.
The device is designed for connection to permanently installed connection cables. The cable glands are suita-
ble for stationary cables and wires.
The device is usually not intended for opening after installation.
If it should nevertheless become necessary to open the device (e.g. to change the operating mode or replace
original spare parts):
➢ Observe the
Safety
➢ Observe chapter
7. Maintenance, service, repairs!
05/2019
Quadro LED-HI-3G/3D Operating Instructions
Directive 2014/34/EU (ATEX)
EN 60079-0: 2012 + A11:2013
EN 60079-15: 2010
EN 60079-31: 2014
II3G Ex nRc IIC T6
II3D Ex tc IIIB T80°C IP66/67 (-20°C  Ta  +55°C)
in the operating manual to prevent possible hazardous electrostatic discharges
information!
(-20°C  Ta  +55°C)
Page 4 / 8 086200013