Unpacking And Cleaning; Machine Identification - T.O.M TRD250 Bedienungsanleitung

UnPaCKinG anD CLEaninG

your new planer thicknesser is shipped complete in a box. Unpack it carefully along with all its spare parts. Take the protective coating off
all the unpainted parts. This protective coating may be removed with a soft cloth moistened with wd40. do not use acetone, petrol or paint
thinner.
Nb: If any parts are damaged or missing, do not connect the planer thicknesser and do not set the switch to ON until the damaged or mis-
sing parts have been replaced or obtained and installed correctly. do not dispose of the packing box before the machine is fully assembled.
1. blade guard
2. Adapter for connection to an extraction system
(Ø 100 mm)
3. Knob
4. Fastening handles
5. Push blocks
6. Rubber pads
7. Planing height setting handle
8. Set of screws and washers
9. blade setting jig
10. Open-ended spanner (blade removal)
11. Metal plate for blocking access to blades
12. Allen key
13. Fence fastening screw
14. Fence fastening washers
15. Set of Allen keys
16. Push stick
17. Chip and sawdust extraction port
18. Switch releasing piece

MaCHinE iDEnTifiCaTiOn

1. blade guard locking knob
2. blade guard arm locking knob
3. blade guard arm
4. blade guard angle adjustment knob
5. Fixed outfeed table
6. Planing height setting handle
7. Machine On/Off switch
8. Fence
9. blade guard
10. Adjustable infeed table
11. Thicknessing height setting knob
12. Thicknesser planer base
18