Werbung
Verfügbare Sprachen
Verfügbare Sprachen
VI
Handling
1. With the "Light " button at the left of the control panel you can turn the light on or off. This is a LED
light which needs very little energy. Therefore it can be permanently switched on.
2. Press the "C / F" button in order to switch displays between "Celsius" and "Fahrenheit".
3. Use the "Up" and "Down" keys (Temp. Control) in the middle of the control panel in order to select
the desired temperature .
3.1. Single zone models:
The left display shows the set temperature, while the right display shows the currently measured
temperature of the wine chamber.
3.2. Dual zone models:
The left display is for the upper zone, the right display for the lower zone.
With the left arrow-button the temperature of the upper zone will be set, while with the right arrow-
button the temperature of the lower zone will be set. While the display is blinking, the set temperature
is shown. When the display stays permanent, the currently measured temperature of the respective
wine chamber is shown.
3.3. Models with active humidifier:
Wine cooler cabinets with active humidifiers show the temperature on the left display, while humidity
in % is shown on the right display.
With the left arrow-button the temperature can be set. While the left display is blinking, the set
temperature is shown. When the left display stays permanent, the currently measured temperature of
the wine chamber is shown.
With the right arrow-button the humidity can be set between 60% and 85% humidity. While the right
display is blinking, the set humidity is shown. When the right display stays permanent, the currently
measured humidity of the wine chamber is shown.
Do set the humidity on 60 – 65%. If you go too high with the humidity, there is a risk that the labels
and corks will suffer harm. If the room humidity is at 50% or above (at common room temperature),
it's recommended to remove the water container in order to avoid too high humidity inside the cooler
and with it avoiding mold from building up. Only use the active humidification system in the dry
season.
If on the right display 'H2' is shown, it indicates that the water container has to be refilled with distilled
water (see section III/4).
S W I S S C A V E
6 3 0 0 Z u g , S w i t z e r l a n d
e m a i l : i n f o @ s w i s s c a v e . c h
Werbung
