Menu „Config"
This menu is used to configure the device. The settings made here are retained
even after turning off or changing the battery.
•
Language: Select from English or German. The input is done with the
arrow keys left and right.
•
Contrast: Adjusts the contrast of the LCD display. The input is done
with the arrow keys left and right.
•
Const amps: enables or disables constant current control. If you press
the left and right arrow then the input is done. If ‚NO' is selected, the
intensity of all the frequency programs (including those that are stored
on the chip cards) is usually set on the voltage and does not have a
constant current control.
•
Speaker: the tone pitch of the internal speaker. Use the arrow keys left
and right to choose 4 or 5 kHz.
•
HW Rev.: Displays the hardware version of the device.
Diamond Shield
Instruction Manual
page 40