Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Running a single program from a sequence
Select the desired sequence with the + and - button. Press the OK button. The
subprograms of this sequence are displayed. Then select the desired sub-
program and run it by pressing the start button. Previously the device checks the
electrical contact (see „Contact control").
Contact control
Before a sequence or a single program is executed, the device checks whether
the required electrical contact is made. If the contact is not good enough, you will
hear a beep every 3 seconds. By pressing the OK button, the frequency program
can be executed anyway. However no effect will occur.
If the required contact is made, the unit displays for a short time the resistance in
k-Ohms and then automatically begins executing the frequency program.
Display
•
In the headline the sequence name and the name of the current single
program are shown in turns.
•
Below is the remaining execution time displayed (minutes: seconds).
•
Below the intensity is displayed.
•
For frequency programs with current control the actual voltage is
displayed on the left side. On the right side the selected intensity is
displayed in milliamps (1/1000 amps).
•
For frequency programs without current control only the voltage in
volts is displayed.
Operating options
•
Pressing the Start Button will interrupt the program.
•
Repressing the Start Button will play the program from the point of inter-
ruption.
•
The intensity can be adjused using the Arrow Keys up and down.
•
Pressing the Exit Button will quit the current application.
Diamond Shield
Instruction Manual
page 39
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
