Important Terms
•
Frequency program: A frequency program includes all properties of a
single application such as the frequency, intensity or duration.
•
Sequence: A sequence is a succession of many frequency programs.
For example, there is a sequence with the name „Diamond Shield", which
includes the frequency programs „DS1", „DS2", ... up to „DS26".
Menu „Main menu"
A few seconds after switching on the device the main menu will appear. You can
always go back to the main menu if you want to leave the submenus by pressing
the EXIT button.
The Main menu shows the following entries:
•
Chipcard: This item is displaed only if a chip card is inserted.
•
Standard: Under this menu item there are preinstalled sequences and
frequency programs available.
•
Configuration: In this menu various settings can be undertaken.
„Standard" menu
Under standard you find the pre-installed frequency programs with which the Dia-
mond Shield Zapper is by default supplied with. Most of these programs consist
of a sequence of several sub-programs.
The first level of the menu shows the available sequences. When a sequence is
selected and then the OK button is pressed, the frequency programs of the selec-
ted sequence are shown.
Executing a sequence
Select the desired sequence with the + and - button. Then press the Start button.
to run the entire sequence. First the device will test the electrical contact (see
„Contact control"). Then all the individual programs of the selected sequence are
executed.
Diamond Shield
Instruction Manual
page 38