Installing The Battery - Unitech PA692 Schnellreferenzhandbuch

Installing the Battery

1. Open the battery compartment
cover by sliding the tabs on both
sides in the direction of the arrows
shown and lift the cover up.
2. Push up the backup battery switch
to the "ON position by using a
stylus to turn on the backup
battery.
3. Slide and position the battery
pack, making sure the battery
contacts are aligned with the
contacts in the compartment.
4. Use your thumb to snap the
battery in place.
5. Replace the battery compartment
cover by pushing down on the
tabs and sliding them back into
place as shown.
NOTE: Make sure the battery compartment cover is securely closed, or you
may be unable to turn ON the terminal.
Copyright 2011 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Unitech electronics co., ltd.
5F., No.135, Ln. 235, Baoqiao Rd., Xindian Dist., New Taipei City 231, Taiwan (R.O.C.)
 
Tel: + 886 2 89121122 Fax: +886 2 89121810

website: www.ute.com
Battery
Compartment
Tab
Backup
Battery
Switch
Battery
Compartment
Contacts