STEP 1 - TURNING ON THE SYSTEM
1
Turning on the PCS-1/PCS-11
If the standby LED is not lit, proceed as follows:
Make sure the monitor is switched on.
•
Press the main power switch on the right side of the PCS-1/PCS-11.
•
Waking up the PCS-1/PCS-11 from STANDBY-Mode
If the standby LED on the front of the PCS-1/PCS-11 is lit, proceed as follows:
Make sure the monitor is switched on.
•
Press the green power/standby button on the remote control
•
Note:
TV-channels until the start screen of the PCS-1/PCS-11 is visible
STEP 2 - ESTABLISH A CONNECTION
2
Establish a connection by dialling manually
Press the CONNECT/DISCONNECT button.
•
Select the desired net-interface:
•
ISDN, ISDN-Multipoint, IP, IP-Multipoint or ISDN-telephone.
Enter the ISDN or IP number of the conference partner into field A.
•
Afterwards select „Dial" or press the CONNECT/DISCONNECT button,
•
in order to establish a connection.
Note:
connection. The maximum of 12 can be adopted - the PCS-1/PCS-11 automatically
connects with the maximum available channels.
Establish a connection by using the telephone book
In the Start menu select „Phonebook" (Push on the navigation button).
•
With the navigation button mark the desired phone book entry.
•
Press the CONNECT/DISCONNECT button.
•
STEP 3 - TERMINATING A CONNECTION
3
Terminating a connection
Press the CONNECT/DISCONNECT button on the remote twice.
•
STEP 4 - TURNING OFF THE PCS-1/PCS-11
4
Turning off the PCS-1/PCS-11
Press the green standby button on the remote, in order to put the
•
PCS-1/PCS-11 into STANDBY mode.
Press the main power switch on the right side in order to switch off the
•
system completely.
If the start screen does not show up on the monitor, change the
In the field number of channels you can define the bandwidth for the
SONY PCS-1/PCS-11
QUICKSTART