Bosch PAM 220 Originalbetriebsanleitung Seite 30

30 | English
1. SPR: Storing the spring angle
The spring angle can be saved as follows:
– Open the fold-out leg and base leg until the required spring angle is
shown on the display.
– Measure the spring angle if it is unknown. For this, place the workpiece to
be measured between the fold-out leg and the base leg.
When measuring particularly narrow or small workpieces with the meas-
uring tool is not possible, use auxiliary equipment such as a bevel angle or
mitre rule, and then adjust the angle on the measuring tool.
Press the COM (7) button to store the measured spring angle for the com-
pound mitre. SPR and the current angle will appear on the display.
2. CNR: Storing the corner angle
1 609 92A 56P | (12.07.2019)
SPR
CNR
CNR
SPR
Bosch Power Tools