Herunterladen Inhalt Inhalt Diese Seite drucken

Bosch PAM 220 Originalbetriebsanleitung Seite 25

Digitaler winkelmesser
Vorschau ausblenden Andere Handbücher für PAM 220:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Do not expose the measuring tool to any extreme temperatures or
u
variations in temperature. For example, do not leave it in a car for ex-
tended periods of time. In case of large variations in temperature, allow
the measuring tool to adjust to the ambient temperature before putting it
into operation. The precision of the measuring tool may be compromised
if exposed to extreme temperatures or variations in temperature.
Keep the supporting surfaces and contact edges of the measuring
u
tool clean. Protect the measuring tool against shock and impact. Dirt
particles or deformations can lead to faulty measurements.
Switching On and Off
To switch on the measuring tool, press the on/off button (11).
After switching on, the measuring tool is in "normal measuring" operating
mode.
To switch off the measuring tool, press the on/off button (11).
When no activity is performed on the measuring tool for approx. 5 minutes,
the measuring tool automatically switches off to save the batteries.
Aligning with the Spirit Levels
The measuring tool can be aligned horizontally with spirit level (5) and ver-
tically with spirit level (6).
The measuring tool can also be used as a carpenter's spirit level for checking
vertical and horizontal lines. For this, place or hold the measuring tool
against the surface subject to checking.
"Normal measuring" Operating Mode
After switching on, the measuring tool is always in "normal measuring" oper-
ating mode.
Measuring Angles (see figures C–E)
Place the fold-out leg  (1) and the base leg (3) flat on the surfaces adjacent
to the angle. The displayed measured value (a) corresponds with the interior
angle w between the base leg and the fold-out leg.
This measured value is shown on the display (4) until you change the angle
between fold-out leg (1) and base leg (3).
Transferring Angles (see figure C)
Measure the angle to be transferred by placing the fold-out leg and base leg
on the target angle.
Bosch Power Tools
English | 25
1 609 92A 56P | (12.07.2019)

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis