Bosch PAM 220 Originalbetriebsanleitung Seite 26

26 | English
Place the measuring tool in the required position against the workpiece. Use
the legs as a straight edge to transfer the angle.
Ensure that the fold-out and base legs are not moved during transfer.
Marking Angles (see figure D)
Open the fold-out leg and the base leg until the required angle is indicated in
the measured value display (a).
Place the measuring tool in the required position against the workpiece. Use
the legs as a straight edge to transfer the angle.
Storing the Measured Value
Press the Hold (9) button to store the current measured value (HOLD).
The measured value is displayed, regardless of whether the base leg and
fold-out leg are moved, until you press the Hold (9) button again.
Measuring with Leg Extension (see figures F–H)
The leg extension (2) makes it possible to measure angles when the contact
surface is shorter than the fold-out leg (1).
Attach the leg extension (2) (see "Attaching the Leg Extension (see fig-
ure B)", page 24). Place the base leg (3) and the leg extension (2) flat on
the surfaces adjacent to the angle.
The measured value of the angle w between base leg and fold-out leg is in-
dicated in the display. The required angle v between base leg and leg exten-
sion is calculated as follows:
v = 180° – w
If you press the 180° button, the required angle v (supplementary angle)
will be calculated and displayed.
v
w
1 609 92A 56P | (12.07.2019) Bosch Power Tools