Klarstein Porterhouse 10030028 Bedienungsanleitung Seite 18

EN
18
Mounting the frame
You can also use this tabletop grill on a stand. A frame including shelves (e.g. for bar-
becue utensils) is included in the product contents. Mount the frame as follows:
• From below, insert one of the support legs through one of the openings at the
corners of the shelf.
• Push the support leg up until the holes in the shelf and support leg are vertically
aligned.
• Insert a screw through the hole from the front Secure the screw by screwing a wing
nut onto it. Mount the three other support legs in exactly the same way.
• Place the support frame on the four support legs from above so that the sup- port
legs run into the guide bars and the holes in the support legs and the guide bars are
vertically aligned.
• Insert a screw through the hole from the front. Secure the screw by screwing a wing
nut onto it. Follow exactly the same steps for the three other corners.
• Place the tabletop grill on the support frame.
• Make sure that the tabletop grill locks into the support frame.
• The frame has now been mounted and you can now use the tabletop grill on a
stand.
OPERATION
First Use
• Remove all leftover packaging.
• Mount the tabletop grill as described in the chapter "Assembly".
• Clean the tabletop grill as described in the chapter "Cleaning".
• Set up the tabletop grill in a suitable location.
• Connect the tabletop grill to a socket with an earthing contact.
• Slide the thermostat control to the "MAX" setting.
• Let the tabletop grill heat up at the highest temperature setting for 10 – 15 minutes.
• Slide the thermostat control to the "MIN" setting.
• To switch the tabletop grill off, first pull the mains plug out of the socket.
• Let the tabletop grill cool off.
• Repeat steps 6 to 10.
• You can now barbecue with the tabletop grill.
Note: Slide the thermostat control to the "MIN" setting be- fore you insert the mains
plug in a socket with earth- ing contact. Do not use any fuels such as charcoal in the
tabletop grill.