Technical Data; Safety Instructions - Klarstein 10029347 Handbuch

Dear Customer,
Congratulations on purchasing this equipment. Please read this manual carefully and take care of the following
hints to avoid damages. Any failure caused by ignoring the mentioned items and cautions mentioned in the
instruction manual are not covered by our warranty and any liability.
Item number
Power supply
• Never attach the fan to a power point, but to the ceiling itself.
• The minimum distance between the blades of the fan and the floor must be 2.3m. The minimum carrying
capacity of the hook from which the fan is hung must be 100kg.
• Make sure to install all poles disconnection switch having a contact separation of at least 3mm between
poles in the supply wiring to the ceiling fan.
• Install only bulbs of the type intended for your fan.
• Switch off the power before connecting or repairing the fan.
• The fan must be properly grounded to avoid the risk of electric shocks.
• Never mount the fan in a moist or wet room. Be careful when working near the rotating blades.
• Always have your fan installed by someone who is knowledgeable about electrical wiring.
• This appliance is not intended for use by persons (including children) with reduced physical. Sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or inst-
ruction concerning use of the appliance by a person responsible for their safety. Page 1 of 3 Children should
be supervised to ensure that they do not play with the appliance.
1. Secure the mounting plate to
a ceiling joist with two screws,
spring washers and flat washers
provided. Ensure the support
for the mounting plate must be
capable of safely and securely
holding the moving weight of
the fan.
5

Technical Data

10029345, 10029346
220-240 V~ 50-60 Hz

Safety Instructions

Mounting
2. Hang the fan assembly onto
the mounting plate. The
mounting plate has a lug on
it; this should be lined up with
the corresponding groove on
the fan assembly ball joint.
3. Connect wires from supply
and bracket to the wiring
terminals as follow:
Brown wire
Blue wire
Green/yellow wire: