Klarstein 10029347 Handbuch Seite 6

4. Connect the internal lead to
the fan body by clipping to-
gether the two plastic male /
female connectors are firmly
clicked together.
7. Assemble blades shanks and
decorative plate onto fan
blades using three screws and
spring washers each.
10. Insert the other two set screws
and washers. Tighten all the
screws, make sure that the
canopy is secure and that
you have not trapped any
wires. Ensure that the slot of
the nylon ball hanger fits into
the guide pin of the upper
canopy.
5. Attach canopy to the bracket
by aligning canopy side holes
with the bracket side holes.
Lift fan until the screws reach
the bottom of the slots and
then rotate the canopy coun-
terclockwise until the screws
drop into the slot recesses
8. Install the fan blade sets onto
the motor by tightening the
screws and spring washers.
11. Attach the two pull cords, en-
sure that the pull cord retaining
clips supports the cord.
6. Insert the other two set screws
and washers. Tighten all the
screws, make sure that the
canopy is secure and that you
have not trapped any wires.
Ensure that the slot of the
nylon ball hanger fits into the
guide pin of the upper canopy.
9. Install light bulb (max 42W E27
not supplied) to the lampholder
6