Klarstein Big Daddy Cool Handbuch Seite 15

OPERATION
Transportation
Don't put it up-down or across, press, and shake, when move it, please don't let the
angle more than 45°. When move please don't put your hand on the door, the top part
and any other pumps.
Placement
Put it where the aeration is well. On refrigerator top, the space should not less than
30cm, both sides and back should be more than 10 cm far from wall. Door could open
more than 120°. Far from the heat, and keep it from the sunshine.
Don't put it in the humidity or near the water, in order not to rust or lessen isolation. The
place should be flat and strong. The wire shouldn't be covered by the refrigerator or
other things. It could keep the accidents away.
Preparation
1 Remove all packing material from the unit before use.
2 Get an overview of all parts.
3 Set up the refrigerator.
4 Clean the interior before using it for the first time.
5 Allow the appliance to rest for approx. 30 Minutes after cleaning.
6 Connect the appliance to the mains.
Commissioning
• Switch on the device. Switch the thermostat to a value between „1" and „5". The
refrigerator starts to operate. After half an hour the refrigerator is cooled.
• Use the thermostat to regulate the temperature.
The Thermostat
The temperature in the refrigerator is controlled by the thermostat. „0" Means that the
appliance is switched off. The appliance cools between „1" and „5". The smaller the
number, the higher the temperature and the shorter the cooling time.
Note: level „5" is intended for fast cooling of food. After cooling down, return the
stage to a normal level.
It may take a little longer for the refrigerator to reach the desired temperature when used
for the first time.
EN
15