Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL 9-13 Originalbetriebsanleitung

Anleitung_Autom_Schweissschirm_SPK1:_
7.2 Adjusting the angle and distance from the
viewing window (Fig. 3-4)
Undo the two locking buttons (Item 5) on the left and
right of the automatic welding screen a few turns.
You can now adjust the angle of the welding screen
in the down position by moving the plastic pins to the
appropriate openings.
Fig. 3:
Position A: Low setting
Position B: Middle setting
Position C: High setting
In addition you can adjust the distance of the face
from the viewing window in three settings by pulling
the welding screen forwards and backwards.
Fig. 4:
Position D: Large distance
Position E: Middle distance
Position F: Small distance
When you have selected the ideal setting for
yourself, tighten the two locking buttons (5) again.
7.3 Setting the head height (Fig. 5)
The head height can be adjusted by moving the
plastic pin on the top headband (8).
7.4 Setting the sensitivity (Fig. 6)
The light sensitivity when the automatic welding
screen is switched on can be adjusted using the
sensitivity setting wheel (11). This can be helpful in
changing light conditions.
7.5 Setting the delay time for brightening
(Figure 6)
The delay time setting wheel (12) enables you to
adjust the delay time for brightening. This function is
designed to adjust the welding screen to take
account of the fact that the workpiece may undergo
final glowing.
7.6 Setting the safety level (Fig. 1)
The safety level controller (4) enables you to adjust
the safety level to the welding method and welding
current you wish to use. A table with the
recommended values for this purpose is provided in
point 10.2.
29.03.2012 10:17 Uhr Seite 15
8. Cleaning, maintenance and ordering
of spare parts
8.1 Cleaning
Keep the automatic welding screen free of dirt
and dust as far as possible. Rub the device with
a clean cloth or use a slightly damp cloth and a
little lubricating soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the appliance.
We recommend that you clean the appliance
immediately after you use it.
Ensure that no water can get into the interior of
the tool.
8.2 Cleaning the fabric cover on the front
headband (Figure 7)
The front headband (Item 10) can be removed for
cleaning. Remove the two plastic buttons from the
appropriate openings and remove the front
headband as shown in Figure 6. Clean the front
headband (Item 10) with a little lubricating soap
under running water.
8.3 Servicing
Dispose of soiled maintenance material and
operating materials at the appropriate collection
point.
8.4 Replacing the safety screen (Fig. 8 – 9/Item 2)
There is a trough handle below the safety screen. To
remove the safety screen glass, reach into this and
remove the safety screen (Item 2) forwards.
To insert the new safety screen, push it together
slightly and press it behind the four retaining pins
(Item G).
The safety screen is made of flexible material and
can easily be bent, but do not kink it.
8.5 Storage
Store the device in a dry place which is not
accessible to unauthorized persons. The storage
temperature range is -20°C to +70°C.
8.6 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
GB
15