Code Lock Operation; Standby Mode; Activating Relay Output 1 "Output 1" (E); Activating Relay Output 2 "Output 2" (F) - BASETech 1833947 Bedienungsanleitung

11. Code Lock Operation

11.1 Standby Mode

The code lock is in standby mode as long as it is not currently in programming mode.
While the code lock is in standby mode the yellow "STATUS" LED (3) blinks at 2 second intervals.

11.2 Activating Relay Output 1 "OUTPUT 1" (E)

Please note that this step is dependent on the input method you selected in
Chapter "10.11 Function Settings (a - Setting Input Method). Depending on the
setting made, the activation is carried out either by pushing the # button after
the user code or not.
The relay output 1 "OUTPUT 1" (E) can be activated depending on the activation method
selected (see Chapter "10.6 Assigning the Activation Method for "OUTPUT 1"):
Activation Method 1: Activation via ID card
Activation Method 2: Activation via user code
Activation Method 3: Activation via ID card and user number
Example for activating relay output 1:
9876 #
You must be in the standby mode in order to be able to activate relay output 1.
If activated the green "PASS" status LED (4) is lit.
The factory setting allows the relay output 1 "OUTPUT 1" (E) to be activated by ID card or user
code.
Activation Method 3: Activation via ID card and user number.
While the green "PASS" status LED (4) flashes it is possible to return to the
standby mode by pressing the "*" key.

11.3 Activating Relay Output 2 "OUTPUT 2" (F)

Please note that this step is on the setting made, the activation is carried out
either by pushing the # button after the user code or not.
The relay output 2 can be activated by entering the user code which you set in Chapter "10.8
Programming User Code to "OUTPUT 2" (F)"
51