Bosch Indego S+ 400 Originalbetriebsanleitung Seite 28

28 | English
Problem Possible Cause
Mower out of peri- Perimeter wire on a slope
meter wire
Obstacle near perimeter wire
Parts of the lawn area Mower requires more cuts to finish garden Allow mower to run for 3 full cuts to cover whole lawn
left uncut
Time slot not long enough for garden size
Distance between perimeter wires too
small
Rough mowing conditions
Grass too long
Slopes in garden too steep
Mower gets stuck in Objects/obstacles not marked out
garden
Newly laid turf
Mower unintentionally Objects/obstacles below 5 cm not marked
cuts flowers, etc. or out
runs over certain
obstacles
Mower does not ap- LogiCut system depends on the garden
pear to cut logically conditions. Mower does not necessarily
have to continue in the next uncut area.
Mower does not always go in a straight line
when travelling between areas
Mower frequently does not find right posi-
tion or turns on the spot
Wire crossed while marking an object
Mower runs in random paths in an addi-
tional lawn without docking station.
Perimeter wire keeps Wire is not taut between pegs
being cut
Distance between pegs is more than 75 cm
Mower leaves ragged The mower does not mow often enough
finish/poor quality of
cut
Cutting blades blunt
Possible clogging
Perimeter wire not No power at the docking station
detected
F 016 L81 862 | (31.10.2018)
Corrective Action
Leave 30 cm between the perimeter wire and the slope.
Remove obstacle.
area.
Increase mowing time slot or use Bosch "SmartMowing"
Calendar Function.
Increase distance between the perimeter wires to a min-
imum of 75 cm.
Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
Flatten garden/remove/bumps/mark out unsuitable
areas with the perimeter wire – Please follow the instruc-
tions in the Installation Guide.
Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
Ensure mower only operates on slopes of 15 degrees or
less and full garden is not on a slope.
Use the perimeter wire to mark off obstacles where the
mower often gets stuck.
Allow a few weeks for the soil to settle before using the
mower.
Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
After watering, wait as long as possible until you start the
mower.
Mark obstacle using perimeter wire leaving 30 cm from
object or remove objects/obstacles.
Further information can be found on the Installation
Guide.
If behaviour re-occurs often, remap garden.
No corrective action needed.
Change wire ID.
Follow instructions in the Installation Guide.
Normal behavior. Th LogiCut system only works in areas
with docking station.
Make wire taut and ensure distance between pegs is
maximum 75 cm. Follow instructions in the Installation
Guide. Use the wire connectors to repair the cut.
Mow more frequently for a good result (e.g. by means of
more/longer slots in schedule).
Reverse or replace cutting blades (see figure K).
Always turn isolator switch off first, then check under-
neath the mower. Clear out as necessary (always wear
protective gloves).
Check if the docking station is powered up (LED is on).
Bosch Power Tools