Mains Connection; Starting Operation - Promac MBS-56CS-M Gebrauchsanleitung

Fig 1
Mount the bottom plate (F) with 2 hex
cap screws, washers and nuts.
Install the two rubber feet (G).
Fig 2
Install the handle (N) to the left side
plate (A) with 4 hex cap screws,
washers nuts (Fig 2).
Fig 3
Install the wheel base (H) with four hex
cap screws, washers and nuts (Fig 3)
Place flat washers on each side of the
wheels (K) and hold in place with split
pins (M).
Install the door (P). The upper hinge
pin is spring loaded.
Install the door lock knob (Q) with a flat
washer and nylon nut.
Mounting Band Saw to Stand:
Place the chip pan (D, Fig 4) on the
stand.
The side with the bigger hole distance
(F) must be towards the left.
With the help of a second person
carefully lift the band saw onto the
stand.
Attach with4 hex cap screws (R) and
washers.
Fig 4
Remove transport lock:
Remove the bracket and two screws
(not shown) which secured the bow
during shipment.
Retain these items in case they are
needed for future transportation.
Pulley Cover and Belt Installation:
The knob (A, Fig 5) should be
loosened.
Fig 5
Slide pulley cover around motor shaft
and worm gear shaft. Secure with two
hex cap screws and washers.
Place the V-belt on both pulleys.
and tighten the lock knob (A).
Close the pulley cover and secure it
with the pan head screw and hex nut.
Stock stop installation:
Insert the stop rod (A, Fig 6) into the
bed and tighten the set screw (B).
Slide stock stop onto the rod and
tighten the set screw (C).
Fig 6

5.3 Mains connection

Mains connection and any extension
cords used must comply with
applicable regulations.
The mains voltage must comply with
the information on the machine licence
plate.
The mains connection must have a
10A surge-proof fuse.
Only use power cords marked H07RN-
F
Connections and repairs to the
electrical equipment may only be
carried out by qualified electricians.

5.4 Starting operation

You can start the machine with the
green on button. The red button on the
main switch stops the machine.
The saw is equipped with an automatic
Shut-Off.
The saw should stop just after the cut
has been completed. The stop tip has
to be adjusted accordingly.