Cleaning And Care; Clean The Pressure Sprayer; Cleaning The Suction Hose And Riser Pipe; Store The Pressure Sprayer - FLORABEST HG01829 Bedienungs- Und Sicherheitshinweise

gauge (see "Building up the operat-
4
ing pressure").
P ull the safety valve
as it will go to release the residual pres-
sure in the container

Cleaning and care

I f the nozzle seems to be blocked, do
not try to blow it free with your mouth.
Note: Clean the pressure sprayer after
each use! Empty the bottle after each use.

Clean the pressure sprayer

U nscrew the spray nozzle
C lean the spray nozzle
water.
I f the spray nozzle
clean it by pushing a needle through it.
F lush through the pressure sprayer,
pipes and tubes with water.
C lean the surfaces of the product with
a moist cloth.
Cleaning the suction hose
and riser pipe
To clean the parts, follow these steps:
Loosen the union nut on the suction hose
on the handle
12
connection on the cover
Open the screw connection on the cover
and pull out the riser pipe.
14
Clean the suction hose
pipe under running water.
After cleaning, reinsert the riser pipe into
the opening provided for this purpose
on the cover and screw this back onto
the tank .
5
upwards as far
3
.
5
.
7
under running
7
is clogged,
7
and on the hose
11
.
14
and the riser
12
Fasten the suction hose
connection on the cover
handle of the spray pipe once more.
11
Tighten the union nut
Store the pressure
sprayer
R elease any residual pressure still present
in the container after use. To do this, pull
the safety valve button upwards until you
can no longer hear the hiss of escaping air.
T horoughly clean the device and allow
it to dry before you put it away for the
winter. This will avoid frost damage.
C lean the pressure sprayer before storing
it away.
R emove any leftover spray product from
the tank and the pipes.
S tore the pressure sprayer in a dry,
dust-free place.

Troubleshooting

If the measures listed below are not success-
ful, contact the manufacturer.
= Fault
= Potential causes
= Remedies
No pressure is established in
the tank.
The pump is not firmly screwed into place.
Screw the pump firmly into place.
The sealing ring of the pump has not
been greased.
Grease the sealing ring of the pump.
onto the hose
12
and the
14
securely.
9
GB/IE 17