Herunterladen Inhalt Inhalt Diese Seite drucken

Bringing Into Use; Attaching The Spray Tube; Filling The Pressure Sprayer Tank; Building Up The Operating Pressure - FLORABEST HG01829 Bedienungs- Und Sicherheitshinweise

Drucksprüher
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

Bringing into use

Attaching the spray tube

(Fig. B–D)
T urn the union nut
release it from the handle
spray tube
into the handle
8
far as it will go.
A ttach the nozzle
Tighten the union nut
direction.
Connect the hose
union nut
on the container
9
the spray pipe handle
Filling the pressure
sprayer tank (Fig. D)
Note: Before using the product, check to
see that it is in good condition and free of
defects.
P ress the pump handle
and turn it anticlockwise.
Note: Before you open the tank, pull
the safety valve
any residual pressure still present in the
container
.
5
D raw the pump
.
5
N ow fill the tank.
Note: Fill the tank with only the
amount of liquid that you actually need
for that particular spraying session (not
more than 5 l).
P lace the pump
tainer
and turn the pump handle
5
clockwise as far as it will go.
16 GB/IE
anticlockwise to
10
. Push the
11
as
11
to the spray pipe
7
8
in a clockwise
10
by fastening the
12
and
5
.
11
downwards
1
upwards to release
3
out of the container
2
back into the con-
2
Building up the
operating pressure
M ove the pump handle
until the pressure sprayer has been
pumped up to a pressure not exceeding
the maximum permissible operating
pressure of 2.5 bar. To ensure this value
is not exceeded, monitor the pressure
.
gauge
4
Note: If the pressure of the air in the
container
sure is automatically released through
the safety valve
P ress the pump handle
into the recesses.
N ow take the spray tube
holder.

Spraying

H ang the pressure sprayer over your
shoulder by the carrying strap
Note: Ensure that the pressure sprayer
is always kept upright. Only when held
in this orientation will the sprayer work
properly.
H old the spray tube firmly by the han-
dle
and direct the adjustable spray
11
nozzle
7
P ress the trigger
process.
R elease the trigger
spraying process.
Note: When the pressure in the con-
tainer
is no longer sufficient to spray,
5
pump the container
1
pressure again up to but not exceeding
the maximum permissible operating
pressure of 2.5 bar. You can check the
operating pressure using the pressure
up and down
1
during the pumping process.
exceeds 2.5 bar, the pres-
5
.
3
downwards
1
out of the
8
e.g. at a plant.
to start the spraying
13
to stop the
13
to increase the
5
.
6

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis