VESTEL VEH14016 Bedienungsanleitung Seite 42

PART 4: USING THE OVEN
Heat setting knobs for vitroceramic cookers
The appliance is operated by using knob control and the heat stored isconfirmed by
residual heat indicator lamp on the vitroceramic surface
1
2
3 4
1
2
3 4
1
2
3 4
1
2
4
3
Knob controlled cooker is designed foroperating at 6 heat
6
levels:
1Keeping warm position
5 2-3Heating position at low heat
4-5-6Cooking – roasting and boilingposition
Dual and oval heaters have two heatingzones. To activate
the outer zone of adual/oval heater, turn the knob to
6
position once. In this way both outerzones switches on.
Residual Heat Functions
After all cooking processes there is someheat stored in the
5
vitroceramic glass called residual heat. The control
cancalculate roughly how hot the glass is in the worst
case. If the calculated temperature is higher than + 60 °
C,then this will be indicated in the related residual
6
inducator heat indicator lamp. The residual heat display is
shown as long as the calculated heater temperature is > +
60° C.
5
After reapplying the supply voltage to the hob control after
an interruption of the supply voltage occurred, causes that
the residual heat display flashes,if the corresponding
heater had a residual heat of greater + 60 ° C before the
6
power interruption occurred. The display will flash until the
max. residualheat time has expired or the heater will be
selected and activated.
5
13