Repairs And Troubleshooting - EFA 750 Originalbetriebsanleitung

5 Repairs and troubleshooting

Malfunction
Machine does not work
Machine vibrates
strongly (possibly loud)
Machine heats up
Machine runs clockwise viewed
from the top
Table 1 list of Faults
6 Cleaning and Maintanace
Disconnect the machine from
the power adapter plug and
mains power outlet before all
cleaning and maintenance
work!
6.1 Daily Cleaning After Completing
Continuous reliable operation can only be as-
sured if the fish scaler is kept hygienically
clean at all times. The machine should normal-
ly be disinfected before each cleaning.
BA-NR.: 001 580 472
Originalbetriebsanleitung
[Produktnummr]
Possible cause
Motor damage through penetra-
tion by water due to a defect
shaft sealing ring on the roller
adapter.
Gear damage.
Screw which fixes the roller is
loose.
Gear damage.
Motor damage
Cable connected incorrectly.
Observe the applicable safety and hygiene
regulations (DIN EN 1672)!
Disinfectants must not be allowed to come into
direct or indirect contact with foodstuffs. Rinse
the machine with clean water after disinfection.
15/24
Remedy
Replace the shaft sealing ring.
Check the motor and replace it,
if necessary.
Check the gear and replace it, if
necessary.
Tighten the screw.
Check the gear and replace it, if
necessary.
Check the motor and replace
it, if necessary
Check machine and adapter
plug
cabling, reconnect if necessary.
Do not use aggressive sol-
vents! Do not use steam or
high-pressure cleaners!
Stand/Version
02/2014
DE-EN