Maintenance; Cleaning The Print Head - Sagem PHOTO EASY 260 Bedienungsanleitung

Liasse AZUR_GB.book Page 29 Lundi, 23. mai 2005 8:43 08
10 M
AINTENANCE
C
LEANING THE PRINT HEAD
Continuous lines across the length of your photographs may be caused by dirt
particles stuck to the print head.
You will need a methylated alcohol
off-the-shelf cotton tips ("Q-tips").
Switch off your printer, disconnect the main cables and wait for five
minutes; since the print head operates at a high temperature, there is a
risk of burning if you touch it.
1. Open the cartridge flap. Press on the locking lever and pull out the
film cartridge.
2. Pull out the paper tray.
3. Turn the printer upside down to remove the lower hatch.
4. Clean the heating line of the print head carefully using a cotton bud.
5. Replace the lower hatch, turn the printer right side up, connect the
mains cable and switch on the printer.
Warning:
never touch the print head with your fingers or any object that might scratch it.
1
4
1. Do not use corrosive chemicals, they may damage your printer.
1
based cleaning product and some
2
- 29 -
3
5