Electrolux WAGL4T300 Benutzerinformation Seite 21

10.9 Cancelling the delay start
To cancel the delay start:
1. Press button Start/Pause to set the
appliance to pause.
The related indicator flashes.
2. Press button Delay Start repeatedly
until the display shows .
3. Press button Start/Pause again to
start the programme immediately.
10.10 Interrupting a programme
and changing a option
You can change only some options
before they operate.
1. Press button Start/Pause.
The related indicator flashes.
2. Change the option set.
3. Press the button Start/Pause again.
The programme continues.
10.11 Cancelling a running
programme
1. Press button On/Off to cancel the
programme and to deactivate the
appliance.
2. Press button On/Off again to activate
the appliance.
Now, you can set a new washing
programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.12 The ProSense load
detection
After touching the Start/Pause button:
1. The indicator
2. The ProSense starts the laundry load
detection to calculate the real
programme duration. The indicator
and the time dots flash.
3. After about 15 minutes the display
shows the new programme duration:
flashes.
the indicator
dots stops flashing.
The appliance adjusts automatically
the programme duration to the load
to achieve perfect washing results in
the minimum possible time. The
programme duration could increase
or decrease.
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
10.13 Opening the Lid when
the programme operates
CAUTION!
If the temperature and level
of the water in the drum are
too high, the lid lock
indicator
you cannot open the lid.
To open the lid proceed as follows:
1. Press the button On/Off for some
seconds to deactivate the appliance.
2. Wait for some minutes and then open
carefully the lid.
3. Close the lid.
4. Activate the appliance and set the
programme again.
10.14 Opening the Lid when
the delay start is active
While the delay start operates, the
appliance lid is locked.
To open the appliance lid:
1. Press button Start/Pause.
The lid lock indicator
2. Open the appliance lid.
3. Close the lid and press button Start/
Pause.
The delay start continues.
10.15 End of cycle
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
ENGLISH
goes off and the time
stays on and
goes off.
21