Electrolux WAGL4T300 Benutzerinformation Seite 27

First try to find a solution to the problem
(refer to the table). If the problem
persists, contact the Authorised Service
Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
• - The appliance does not fill with
water properly. Start the appliance
again by pressing Start/Pause button.
After 10 seconds the lid will be
unlocked.
• - The appliance does not drain
the water.
13.2 Possible failures
Problem
The programme does
not start.
The appliance does not
fill with water properly.
The appliance fills with
water and drains imme‐
diately
•
•
•
Possible solution
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that the appliance lid and drum doors are
closed properly.
• Make sure that there is no damaged fuse in the fuse
box.
• Make sure that the Start/Pause has been touched.
• If the delay start is set, cancel the setting or wait for the
end of countdown.
• Deactivate the Child Lock function if it is on.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
• Make sure that the water tap is not clogged.
• Make sure that the inlet hose has no kinks, damages or
bends.
• Make sure that the connection of the water inlet hose is
correct.
• Make sure that the filter of the inlet hose and the filter of
the valve are not clogged. Refer to 'Care and cleaning'.
• Make sure that the drain hose is in the correct position.
The hose may be positioned too low. Refer to "Installa‐
tion instruction".
- The appliance lid is open or
not closed correctly. Please check the
lid!
- The mains supply is unstable.
Wait until the mains supply is stable.
- The anti-flood device is on.
Disconnect the appliance and close
the water tap. Contact the Authorised
Service Centre.
WARNING!
Deactivate the appliance
before you do the checks.
ENGLISH 27