EFA SB 288 E Betriebs- Und Wartungsanleitung Seite 24

6. Saw cut frayed
7. Band jumps from wheel
8. No water during cleaning
(saw)
9. No water during cleaning
(operation)
Schmid & Wezel
D75433 Maulbronn,
Table 1: Troubleshooting splitting saw
Saw band guide mechanism worn
Strip (front or rear) holding the
guide worn out, so that the guide
is in an inclined position
The bolt of the suspension of
band saw is worn, causing the
saw to be suspended at an angle
Band positioned incorrectly, no
tooth set
Guide wheel at front or rear worn
Guide wheel at front or rear worn
Band tightening torque too low
Wheel ball bearings (front/rear)
worn out
Frame misaligned
Connection of solenoid valve
loose
Solenoid valve defective
Nozzles or water pipe blocked by
limestone or dirt
Water connection defective or
loose
Water hose not connected or
supply system defective
Page / Seite
10 / 27
See chapter 4.2 "Saw band
guides" (page 6)
Replace strip; always replace the
strips in pairs (front and left)!
Correct suspension or replace
bolt
Insert band so that the teeth face
the motor, see chapter 4.2 "Saw
band guides" (page 6)
Check wheels; replace, if
necessary
Check wheels; replace, if
necessary
Retighten band with the torque
wrench
Check bearing play; replace
bearings, if necessary
Cannot be repaired; purchase
new frame and remount
individual parts
Check hose; replace, if necessary
Check valve; replace, if necessary
Clean parts; replace, if necessary
Check hose; replace, if necessary
Check and repair
Version / Ausführung