EFA SB 288 E Betriebs- Und Wartungsanleitung Seite 21

Open the lids (B), see chapter 4.1.1
"Dismantling saw band" (page 6).
Tighten the saw band, see chapter 4.1.2
"Changing saw band" (page 6).
Figure 6: Distance between drive/guide wheel to
saw band
Changing guide
The figure shows the bar of model SB295; the pro-
cedure for changing the guide mechanism is the
same for models SB287, SB288 and SB295
If the gap is wider than 2. mm, change the fibre
guide (see figure 7).
Gap width max. 2.0
Figure 7: Changing guide
Removing guide from strip
To remove the guide from the strip, proceed as
follows:
Schmid & Wezel
D75433 Maulbronn,
Free rotation
Fibre guide
New: 0.6 mm
Page / Seite
7 / 27
Complete guide mechanism
Figure 8: Guide
1. Push guide up.
Figure 9: Guide pushed up
2. Hold guide in top position.
Figure 10: Guide in top position
3. Remove the lever (64) from the holder.
Lever (64)
Version / Ausführung
08.2005