EFA SB 288 E Betriebs- Und Wartungsanleitung Seite 22

Figure 11: Lever (64)
Figure 12: Removing lever from holder
4. Dismantle the guide and lever.
Figure 13: Dismantling guide and lever
4.3 Adjusting spring-loaded pulley
The spring-loaded pulley can be adjusted by turning
the PLUS/MINUS screw at the housing (see figure
14).
Figure 14: Spring-loaded pulley
Turn the screw in MINUS direction until the tool
is balanced and suspended at the correct
height.
If it is not possible to pull more cable from the
pulley, it is jammed and must be readjusted.
Turn the screw in PLUS direction until cable can
be pulled from the pulley and repeat the fine
adjustment (see above).
5. Maintenance
Malfunctions that might occur during operation can
generally be eliminated very simply. Table 1:
"Troubleshooting" lists possible faults, their causes
and remedies.
Schmid & Wezel
D75433 Maulbronn,
Lever (64)
Page / Seite
8 / 27
Version / Ausführung
08.2005