Warning Mode; Cleaning And Maintenance - Fakir HYPO CLEAN Benutzerhandbuch

EN
As shown in <Fig. 6>
As shown in <Fig. 7>
As shown in <Fig. 8>

Warning Mode

As shown in <Fig. 8>, all LED lights flash.
If the water in the spray bottle is not enough or there is too much salt in the water, all
the LED lights will flash after a beep (3 consecutive beeps).
If you want to stop the warning sound, press and hold the Start Button for 5 seconds.
If the button is not pressed, the warning sound keeps for 3 minutes and then the
appliance goes into the Standby Mode.

Cleaning and Maintenance

• Do not leave water on the spray bottle for a long time. If it is not to be used for a long
time, store the appliance (with a spray bottle and spray head, etc.) in a completely
dry place, free from moisture or direct sunlight. If the appliance is stored at very low
temperatures, the efficiency may be reduced and the appliance may fail due to water
frost. Storing at very low temperatures can cause the performance of the appliance to
drop and the water in the container to freeze.
Completion Mode
As shown in <Fig. 6>, the red LED light for the
mode you selected and the white LED light
for the Start Button will remain on. When the
electrolyzed water production is complete, the
appliance goes into the Completion Mode with 3
consecutive beeps.
Buttons are not activated in Completion Mode
for the balancing of the appliance. This mode
takes 1 minute. Please wait 1 minute to run
the appliance once again; the appliance will
automatically go into the Sleep Mode at the end
of this time.
Sleep Mode (Power Saving Mode)
As shown in <Fig. 7>, all LED lights are off; this
mode is called the Power Saving Mode. This is
to minimize the power consumption. If the button
is pressed for 5 seconds in the Standby Mode,
or the buttons are not touched for 3 seconds,
the appliance goes into the Sleep Mode.
If you want to return to standby mode, press the
button for 1 second.
When the Completion Mode ends, the appliance
goes into the Sleep Mode automatically with a
beep sound. If you want the appliance to return
to Standby Mode, put the water bottle back on
the Body and press the button for 1 second.
26