Cardin Elettronica S449 Inbetriebnahme Und Benutzung Technische Installations- Und Referenzzeichnungen Seite 16

been inserted (fig. 6, 7, 8).
1. Make sure that the jumper "J3" has been inserted in receiver.
2. Using a transmitter, in which at least one channel button "A,B,C or D" has already been memorised
in the receiver, press the button "MR" as shown in figure "5".
Note: all the receivers within range when the channel button is pressed (and which have at least one
of the transmitter channel buttons memorised) will activate their signal buzzer "B1" (fig. 6, 7, 8).
3. Press one of the channel buttons on the transmitter. The receivers which do not contain that channel
code will sound a five-second long "beep" and will then disactivate. The receivers which contain the
channel code will sound a one-second long "beep" and will enter the programming mode.
4. Press one of the channel buttons on the transmitter which you wish to memorise; the receiver will
sound 2 "beeps" of half a second each after which the receiver will be ready to receive another code.
5. To leave the programming mode wait for 5 seconds without pressing any buttons. The receiver will
sound a five-second long "beep" and will then exit the programming mode.
• When the memory is entirely occupied the buzzer will sound 10 rapid "beeps" and will automatically
leave the "programming via radio" mode.
Led "L1" will remain lit on the receiver. The same signal is given each time you try to enter "program-
ming via radio" when the memory is full.
16