Setting The Clock; Setting The Timer Function - Easy Temp ECP 06 Einbau- & Anleitungshandbuch

4. USER INTERFACE (continued)

4.2 Setting the clock

The clock can be set in ON or OFF mode. Press CLOCK once and the display
flashes then press CLOCK again and the hours flash. Set the hour using
the arrows or then press CLOCK again to select minutes. Set the
minutes using the arrows or . Press CLOCK again to confirm. The
display returns to its previous status.
Note: Settings are saved by pressing the CLOCK button or are saved
automatically if no button is pressed after 5 seconds.

4.3 Setting the Timer function

This function needs to be set if you want to run your heat pump for a shorter
period than the one set by the filtration clock. You can therefore programme
a delayed start and an early shutdown or simply stop a particular period from
running (e.g. the night).
Start Programme (Timer ON) / Start
1) Press Timer ON, the hour flashes.
2) Press Timer ON to set the hour using the buttons .
3) Press Timer ON to set the minutes using the buttons .
Settings are saved by pressing the Timer ON button or are saved
automatically if no button is pressed after 5 seconds.
A green light indicates that the timer is on.
Stop programme (Timer OFF)/Stop
1) Press Timer OFF, the hour flashes.
2) Press Timer OFF to set the hour using the buttons .
3) Press Timer OFF to set the minutes using the buttons .
Settings are saved by pressing the Timer OFF button or are saved
automatically if no button is pressed after 5 seconds.
A red light indicates that the timer is on.
13