Siemens SITRANS Probe LR Kurzanleitung Seite 10

PROGRAM Mode Display
3
2
1
6
Programming
Do not use the handheld programmer at the same time as SIMATIC PDM, or erratic
Note:
operation may result.
• Set parameters to suit your specific application.
• Activate PROGRAM mode at any time, to change parameter values and set operating
conditions.
• For local programming, use the Siemens hand programmer.
• For programming from a distance, use either a PC running SIMATIC
handheld communicator.
Hand programmer.
For direct access to SITRANS Probe LR,
point the programmer at the
SITRANS Probe LR display and press
the keys. (For detailed instructions, see
the next page.)
hand-held programmer
display
max. 600 mm
(2 ft)
1.
SIMATIC® is a registered trademark of Siemens AG.
Page EN-8 SITRANS Probe LR – QUICK START MANUAL
1 – Primary Reading (displays parameter value)
2 – Secondary Reading (displays parameter number)
3 – Programming indicator
6 – Auxiliary Reading (displays parameter names for P001 to
P010, if a language is selected. It displays the index value
for indexed parameters, such as P054)
Key
Values
to
Decimal point
Negative value
CLEAR value
TOGGLE between Units and % on parameter
value
End PROGRAM session and enable RUN mode
Update echo quality parameters
Parameter scroll-up
Parameter scroll-down
DISPLAY opens parameter fields
ENTER the displayed value
1
PDM or a HART
Programming Mode
7ML19985QP81