Fragrant Pump; Information On Service And Maintenance - EOS SteamTec Premium Gebrauchsanweisung

If the programming step P5 = 00 has been selected in the service programming, no tank
fl ushing takes place. Caution! This may lead to destruction of the heating rods!
If the programming step P5 = 01 is selected in the service programming (factory set-
tings), the tank is fl ushed if the generator is (automatically or through the operator)
switched into Stand-by mode after a period of 30 min. has passed. The prerequisite
for this is that the operating time set in program step P9 (10/20/30 hours) has been
exceeded. E 35 is shown in the display. "E" stands for the tank fl ushing function, and
"35" is the time passing in minutes until fl ushing of the tank has been completed and the
generator can be put back into operation.
If the ball valve has closed again after fl ushing of the tank, the generator can be put
back into operation. The command "Motor closed" stops during operation.

3.2. Fragrant pump

A hose pump is used for dosing whichsafely pumps even the
smallest dosages even if air or gas bubbles are enclosed in
the intake line. Rotating rollers press the dosage tube
against the wall and the liquid that is inside the hose is
pressed out by the rollers and suctioned off immediately. Its
function is extremely safe and it is also easy to operate.
Fragrance concentrates are extremely aggressive. The
dosage tube is resistant to most of the commercially avail-
able concentrates.
Caution:When using non-certifi ed fragrances we shall
not guarantee the service life of the tubing set.
3.2.1 Check / replace the dosage tube
The hose set in the pump is subject to mechanical load. Therefore, the pump hose must
be checked with each fragrance check in order to detect any damages ahead of time
and to replace the hose set.
Generally, the hose set must be replaced every year; more often with aggressive fra-
grances.

3.3 Information on Service and Maintenance

3.3.1 Service
• Please note that all work may only be carried out by licensed specialist personnel.
• The steam generator must be disconnected from the mains prior to carrying out
service work.
• Please contact your authorised EOS partner should you have further questions, or
require support or service.
22 GB