Main Menu - Carl Valentin DPM III XI Schnellreferenzhandbuch

DPM III xi
Key:

Main Menu

After switching on the direct print module, the display shows the following:
Key:
Key:
Key:
Key:
Key:
Key:
Key:
Key:
Key:
94
TRB = Transfer ribbon advance warning:
Before the end of transfer ribbon, a signal is send by the control output.
Warning diameter:
Setting of transfer ribbon advance warning diameter.
In case you enter a value in mm then a signal appears via control output when reaching this
diameter (measured at transfer ribbon roll).
Ribbon advance warning mode:
Warning: When reaching the transfer ribbon advance warning diamter, the corresponding I/O
output is set.
Error: The printing system stops when reaching the transfer ribbon advance warning diameter
with the message 'too less ribbon'.
First line = main menu.
Second line = current date and time.
Second line = version number of firmware.
Second line = build version number of software.
Second line = creation date of firmware version.
Second line = creation time of firmware version.
Second line = font version of bitmap fonts.
Second line = font version of vector fonts.
Second line = version numbers of both FPGA (P = printhead; I = I/O)
Second line = version number of Boot software.
Second line = memory space of FLASH in MB.
English