Layout Settings; Ribbon Save - Carl Valentin DPM III XI Schnellreferenzhandbuch

DPM III xi
Key:
Key:
Key:

Layout Settings

Keys: , ,
Key:
Key:
Key:
Key:
Key:
Key:

Ribbon Save

Keys: , , ,
88
Brake:
If module is installed in vertical position, the option brake should be available and set to On
Delay:
Indication of delay in 1/100 seconds. The closure fo brake can be delayed.
Head delay:
Setting of time between moving down and start of movement of printing carriage can be set.
Backfeed delay:
Setting of time between end of print cycle and beginning of return of the printing carriage to the
zero point.
Printlength:
Indication of way which the print mechanics has to move. The print length depends on the
length of the print mechanics.
Column printing:
Indication of width of one layout as well as how many layouts are placed side by side.
Material: Selection of the used print materials.
Flip layout:
The axis of reflection is in the middle of the layout. If the layout width was not transferred to the
print module, automatically the default layout width i.e. the width of the printhead is used. It is
recommended to use layouts with the same width as the printhead. Otherwise this can cause
problems in positioning.
Rotate layout:
According to standard the layout is printed ahead with a rotation of 0°. If the function is
activated, the layout is rotated by 180° and printed in reading direction.
Alignment:
The adjustment of layout is effected only after 'flip/rotate layout', i.e. the adjustment is
independent of the functions flip and rotate.
Left: The layout is aligned at the left-most position of printhead.
Centre: The layout is aligned at central point of printhead.
Right: The layout is aligned at right-most position of printhead.
Press key so switch the ribbon save function On or Off.
English