Cleaning And Maintenance - Bartscher ARMADIO 1200 Bedienungsanleitung

ARMADIO FRIGO
9.

CLEANING AND MAINTENANCE

Wash the inside of the refrigerator with water and neutral detergent. Then dry it
carefully and position the slives and shelves according to your needs ( at least
every six months).
Adjust the thermostat (see detail nr. 6) or the control board according to enclosure
on the desired working temperature (from + 15°C to -2°C for model TN and from
-18°C to -20°C for model BT). Clean periodically the condenser with a brush or a
vacuum cleaner after having switched off the electrical contact.
9.1 ELECTRIC WIRE SUBSTITUTION
If the electric wire is damaged, the substitution must be done by the producing firm, by
its assistance service, or by a qualified engineer. In any case, be sure of having
unplugged before proceeding in such operation.
10.
BAD WORKING
In case of abnormal rising of inside temperature of the apparatus, check first of
all whether:
• the plug is fixed well on the socket
• there are voltage variation of ± 10%.
•
In case of bad working after having checked the above mentioned points, please,
call your supplier.
Tell him the type of your refrigerator and its serial number: you will find them on the
data board of each apparatus.
In case of substitution of the 15 W illumination bulb (part. 15) in the inferior part of the
electric stainless steel panel be sure of having unplugged from the electrical socket
before proceeding in such operation.
Remove the PVC light cover (part. 14) taking off the fixing screw from the electric
stainless steel panel (part. 2), unscrew from the lamp support the damaged illumination
bulb, substitute it with a new one with same power, and replace the PVC light cover.
11.
IMPORTANT
The guarantee must be filled in and sent to the producer company within eight days
after the start-up.
d.07/10
15