Initial Settings; Adjusting Initial Settings; Setting The Clock; Setting The Fm Tuning Step - Pioneer KEH-series Bedienungsanleitung

Section

Initial Settings

07

Adjusting initial settings

Initial settings lets you perform initial set up of
different settings for this unit.
1 Press SOURCE and hold until the unit
turns off.
2 Press AUDIO and hold until clock ap-
pears in the display.
Press AUDIO repeatedly to switch between
the following settings:
ClockSTEP (FM tuning step)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down AUDIO until the unit turns off.

Setting the clock

Use these instructions to set the clock.
1 Press AUDIO to select clock.
Press AUDIO repeatedly until clock appears in
the display.
2 Press c or d to select the segment of
the clock display you wish to set.
Pressing c or d will select one segment of the
clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
12
En
HHHHHHHHHHHHHH
3 Press VOLUME up/+ or down/ to set
the clock.
Pressing VOLUME up/+ will increase the se-
lected hour or minute. Pressing VOLUME
down/ will decrease the selected hour or min-
ute.

Setting the FM tuning step

The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Press AUDIO to select STEP.
Press AUDIO repeatedly until STEP appears in
the display.
2 Press c or d to select the FM tuning
step.
Pressing c or d will switch the FM tuning
step between 100 kHz and 50 kHz. The se-
lected FM tuning step will appear in the dis-
play.
Note
If seek tuning is performed in 50 kHz steps, sta-
tions may be tuned in imprecisely. Tune in the sta-
tions with manual tuning or use seek tuning
again.
Black plate (12,1)
<CZR2964-A>12