Starting And Stopping - Sandri Garden TL 60 Bedienungsanleitungen

N) Cutter guard
O) Work depth ploughshare
P) Cutters
Q) Reduction unit
R) Transport wheel
S) Tine disks (only TL 60)
4. ASSEMBLY (F
A) - HANDLEBAR PLATE
Fit the handlebar retention plate (1) on the MO-
TOR HOE chassis using the 4 screws (2) and
secure by means of the nuts (4).
B) HANDLEBARS
Fit the two handlebars (5-6) in the handle hold-
ing plate and secure using the screws (8) and
the knobs (7), being careful to place the plate
(3) in between.
C) WORKING DEPTH ADJUSTMENT BAR
Fit the bar (9) inside the body, place the washer
(10) in between and fix it with the cotter pin (11)
5. STARTING
The engine is shipped without oil.
DO NOT START until the sump has
been filled with oil.
DO NOT FILL OVER MAXIMUM
LEVEL.
Before starting, refer to the at-
tached motor manufacturer's
manual.
MOTOR HOE OPERATING MANUAL
.2)
IG
IMPORTANT !!
IMPORTANT !!
1) Always prepare fuel and refuel out
of doors.
2) Keep the fuel in a container specially
intended for this purpose and keep the
container cap well tightened.

6. STARTING AND STOPPING

IMPORTANT! Carefully keep to the in
structions provided in Chap. 2 FUN-
DAMENTAL SAFETY PRECAUTIONS.
INSTRUCTIONS FOR MOTORS WITH AIR
CONTROL ON THROTTLE LEVER (Fig.3)
The lever controls motor speed. For cold starting
the lever must be on
A warm motor can be started in MAXIMUM po-
sition .
Best MOTOR HOE performance is obtained in
MAXIMUM position
INSTRUCTIONS FOR MOTORS WITH FUEL
PUMP (BULB) (Fig.4)
The lever controls motor speed. For cold start-
ing the lever must be in MAXIMUM (2) position
. Next, pump the bulb of the "primer" pump
(fig.11) before starting the motor. (If the motor
stops due to lack of fuel, top up the tank and
press the supply pump 3 times).
NOTE: Generally speaking, the pump will not
be required if the motor is already warm on start-
ing. Nevertheless, in cold climatic conditions,
the initial operation may have to be repeated.
GB
(2).
.
Fig. 11
21