Appendix; Trouble-Shooting - Logic Data Ir-Fernbedienungs-System Bedienungsanleitung

Appendix

Trouble-shooting:

Defect
Drives do not move at all
IR-receiver beeps, when
trying to move the drives
IR-receiver beeps 3x right
after plugging in
Green LED on IR-
transmitter is not on
Drives stop shortly during
motion
If a system component still does not work, please contact our customer service or
the retailer where you have bought this system.
Cause Correction
Control not Plugging in mains cable
plugged in
IR-receiver Plugging in IR-receiver
not plugged
in
Insufficient plug Correctly plugging in plug
contact
Wrong Setting correct channel
channel set
Keylock Deactivating keylock
active
Channel Deactivating channel selection
selection mode or setting channel
mode active
Batteries not Putting in batteries
put in
Batteries Putting in new batteries
empty
Batteries put Correctly putting in batteries
in incorrectly
Another IR- Always using one IR-receiver at
receiver used a time only.
in the same
room at the
same time.
The IR- Avoid direct incident light
receiver is radiation (e.g. desk lamp) or
exposed to keep distance to the interfering
too strong light source ( at least 1m)
interference
light
- 20 -