Channel Set-Up Ir-Receiver - Logic Data Ir-Fernbedienungs-System Bedienungsanleitung

Now the second digit of the channel number has to be put in.
ð
PRESS ONE KEY OUT OF
BEEN 0, OR OTHERWISE ONE KEY OUT OF
First the transmitter LED blinks once and then twice.
New channel is set.
Channel selection mode is deactivated.
If no key is pressed within 10 seconds during channel set-up or if the wrong
key is pressed, channel selection mode is left automatically. The originally
set channel remains unchanged. Exit is indicated by the transmitter LED
blinking twice.
Information:
If a channel has once been set it will remain unchanged even if the
batteries are taken out.

Channel set-up IR-receiver:

Channel selection
To be able to put in the channel number, the IR-transmitter is required for
channel set-up on the IR-receiver.
First the IR-receiver must be switched to channel selection mode.
Normal position
Reserve
- 18 -
TO , IF THE FIRST KEY HAS
TO
Channel switch
.