Channel Set-Up; Channel Set-Up Ir-Transmitter - Logic Data Ir-Fernbedienungs-System Bedienungsanleitung

How to deactivate the keylock:
ð
KEEP KEY
The transmitter LED blinks once.
Now the system is ready for operation again.
Information:
If someone tries to operate the system as long as the keylock is active, the
receiver will beep. The keylock will be active for up to 5 minutes after the
batteries have been taken out.

Channel Set-up

With the help of this IR-system up to 16 different channels can be set. For
delivery the IR-transmitter as well as the IR-receiver are set to channel 00.
So the IR-system is ready for operation at any time.
The set-up is carried out separately on the IR-receiver and on the IR-
transmitter. A channel can also be set if different channels have already
been set on the IR-transmitter or on the IR-receiver.
However for drive operation it must be observed that the same channel
must be set on both the IR-transmitter and the IR-receiver.
Attention:
The drives can only be operated if the same channel is set on both the IR-
receiver and the IR-transmitter.

Channel Set-up IR-transmitter:

First the transmitter has to be switched to the so-called channel selection
mode.
ð
KEEP KEY
Channel selection mode is active, transmitter LED blinks twice.
Now the two-digit channel number has to be put in. Channel numbers from
00 to 15 are permissible. Put in the first digit first:
ð
PRESS KEY
Transmitter LED blinks once.
PRESSED FOR
CA
PRESSED FOR
CA
.
OR
- 17 -
. 2.5 SECONDS.
. 2.5 S .
ECONDS