Installation And Start-Up; Putting Batteries Into The Ir-Transmitter; Installation Of Ir-Receiver - Logic Data Ir-Fernbedienungs-System Bedienungsanleitung

Installation and Start-up

Putting the Batteries into the IR-Transmitter:
ð
REMOVE THE COVER OF THE BATTERY BOX.
ð
PUT BOTH ORIGINAL BATTERIES INTO THE BATTERY BOX.
PLEASE PAY ATTENTION TO THE CORRECT POLARITY. ® see
illustration
ð
CLOSE THE COVER OF THE BATTERY BOX AGAIN.
Installation of the IR-Receiver:
ð
PLUG THE IR-RECEIVER (BLUE PLUG) INTO THE MOTOR
CONTROL (HS-SOCKET; BLUE POINT) .
The IR-receiver beeps once.
If the IR-receiver beeps three times after having been plugged in, the
channel selection mode of the IR-receiver is active. In this case one of the
following steps have to be carried out:
ð
BRING
RIGHTMOST POSITION.
The IR-receiver beep twice.
Channel selection mode is deactivated.
ð
SET THE DESIRED CHANNEL.
® see channel set-up IR-receiver.
With the help of the adhesive disk supplied with the system, the IR-receiver
can be mounted at a suitable place. However it must be taken care that the
receiver will not be covered by other objects, as IR-transmission would be
impossible then.
THE CHANNEL
- 14 -
SELECTOR SWITCH INTO THE