Logic Data IR-FERNBEDIENUNGS-SYSTEM Bedienungsanleitung Seite 19

ð
B
RING THE CHANNEL SWITCH OF THE
.
POSITION
The IR-receiver beeps twice.
Channel selection mode is active.
Now the two-digit channel number has to be put in. Channel numbers from
00 to 15 are permissible. Put in the first digit first.
ð
PRESS KEY
The IR-receiver beeps once.
Now the second digit of the channel number has to be put in.
ð
PRESS ONE KEY OUT OF
OR OTHERWISE ONE KEY OUT OF
IR-receiver beeps once.
ð
B
RING THE CHANNEL SWITCH OF THE
.
POSITION
IR-receiver beeps twice.
New channel is set
Channel selection mode is deactivated.
If a wrong key is pressed during channel set-up, the receiver beeps three
times. If the channel selection mode shall be aborted, the last step has to
be carried out earlier. So the channel selection mode is left automatically.
There the originally set channel remains unchanged. When leaving the
channel selection mode, the IR-receiver beeps twice.
.
OR
TO
TO
- 19 -
IR-
RECEIVER INTO THE LEFTMOST
, I
F THE FIRST KEY HAS BEEN
.
IR-
RECEIVER INTO THE RIGHTMOST
0,