Hatco Toast-Qwik Serie Installations- Und Bedienungshandbuch Seite 13

Toast Feed Ramp
The toast feed ramp is installed at the factory and can be used
in two positions. See 6 .
1. When in the upright position, the toaster is set for
automatic feed. Bread products enter the toaster by
placing them on the feed ramp and releasing.
2. For manual feeding of product, tip the feed ramp until it
rests on top of the unit. In this position bread products can
be manually loaded by placing directly on the conveyor
belt.
CAUTION
Some exterior surfaces on the unit will get hot. Use
caution when touching these areas to avoid injury.
Toast Crumb Tray
Install toast crumb tray directly below the conveyor belt and
below the stop pins. Insert until the front of the crumb tray
meets the stop pins. See 7 .
CAUTION
To avoid damage to the unit or injury to personnel always
operate toaster with crumb tray installed.
CAUTION
To avoid any injury, do not remove the crumb tray for
cleaning until toaster is cool.
Front or Rear Discharge
Toast-Qwik units can be set up so toasted product discharges
at either the front or the rear of the unit.
WARNING
To assure safe and proper operation while operating in the
Front Discharge mode, allow a minimum clearance of
25 mm (1") along the sides and rear. Allow a minimum
clearance of 305 mm (12") along the front.
WARNING
To assure safe and proper operation while operating in the
Rear Discharge mode, allow a minimum clearance of 25
mm (1") along the sides. Allow a minimum clearance of
305 mm (12") along the front and rear.
TQ-10 & TQ-15 MODELS ONLY
The TQ-10 & TQ-15 models use a one piece discharge
chute/collector pan. The installation location determines
discharge area.
For front discharge install toaster chute from the front of the
toaster with the curved end inward and the rear lip of the chute
on the rear most pins. See 8 .
For rear discharge install toaster chute from the rear of the
toaster with the curved end in, and the lip of the chute over the
inside set of pins. See 9 .
TQ-400, -800, -1200 & -1800 SERIES
TQ-400, -800, -1200 and -1800 series toasters use a separate
discharge chute and collector pan.
For front discharge install the chute first by placing the curved
end inward until the rear lip of the chute is on the upper most
set of pins and the front slots on the chute are on the inside set
of pins. Position the collector pan, with the open end in first,
over the remaining sets of pins. Align slanted notches over the
pins and lower into place. See 10 .
For rear discharge the TQ-400, -800, -1200 and -1800 series
toasters do not use the discharge chute. If the chute is installed
remove it. To set-up toaster for rear discharge position, install
the collector pan, with the open end first, over the set of pins at
the rear of the unit. Align the straight notches over the pins and
lower into place. See 11 .
13
INSTALLATION
Form No. TQ2CEM-1105