Adjusting The Clock Function - Hayward Pools ENERGYLINE ELE0601 Einbau- & Anleitungshandbuch

4. USAGE AND OPERATION

4.5 ADJUSTING THE CLOCK FUNCTION

You need to set and adjust the clock function if you want to operate the heat pump
over a shorter period of time than the time specified by the filtration timer. Then you
can programme a later start-up and an earlier stop for your heat pump.
Programming start-up (Timer On)
The heat pump must be switched on and in stop mode (the time is displayed on the
screen).
1) Press the Timer On button to activate the timer and the clock will flash by
default (00:00)
2) Press the Timer On button a second time to enter the hours using the right and
left arrows.
3) Press the Timer On button a third time to enter the minutes using the right and
left arrows.
4) The time is automatically saved after 5 seconds without any need to press the
clock and a green light is displayed.
Programming Stop (Timer On)
The heat pump must be switched on and in stop mode (the time is displayed on the
screen).
1) Press the Timer Off button to activate the timer and the clock will flash by
default (00:00)
2) Press the Timer Off button a second time to enter the hours using the right and
left arrows.
3) Press the Timer Off button a third time to enter the minutes using the right and
left arrows.
4) The time is automatically saved after 5 seconds without any need to press the
clock and an orange light is displayed.
Removing the Clock function
1) Press the Timer On button, the time flashes, then press the clock button and the
green light will go out
2) Press the Timer Off button, the time flashes, then press the clock button and the
orange light will go out
11