Preface - Hayward Pools ENERGYLINE ELE0601 Einbau- & Anleitungshandbuch

1. PREFACE

In order to provide our customers with quality, reliability and versatility, this product has been
made to strict production standards. This manual includes all the necessary information about
installation, debugging, discharging and maintenance. Please read this manual carefully before
you open or maintain the unit. The manufacturer of this product will not be held responsible if
someone is injured or the unit is damaged as a result of improper installation, debugging, or
unnecessary maintenance. It is vital that the instructions within this manual are adhered to at all
times. The unit must be installed by qualified personnel.
• The unit can only be repaired by qualified installer centre personnel or an authorised dealer.
• All electrical connections must be done by a qualified electrician according to local electrical
standard.
• Maintenance and operation must be carried out according to the recommended time and
frequency, as stated in this manual.
• Use genuine standard spare parts only.
• Failure to comply with these recommendations will invalidate the warranty.
• The Swimming Pool Heat Pump Unit heats the swimming pool water and keeps the
temperature constant.
Warning as regards children/people with reduced physical capacity:
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
This type of pump has the following characteristics:
1. Durable
The heat exchanger is made of PVC & titanium; the tube can withstand prolonged exposure
to corrosives such as chlorine.
2. Quiet operation
The unit comprises an efficient rotary compressor and a low noise fan motor, which
guarantees its quiet operation.
3. Electronic control board
The unit is controlled by a micro-controller, allowing all operation parameters to be set.
Operation status can be displayed on the control panel.
1