Specifications - Rockford Fosgate Prime R500-1 Einbau Und Betrieb

S
PECIFICATIONS
MODEL- PRIME
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts*
4 Load Mono
2 Load Mono
Dimensions: Height
Width
Length
Amplifier Fuse Rating (Amp)
Battery Fuse Rating (Amp) External (Not Supplied)
"A" Weighted Signal to Noise Ratio
Referenced to 1 Watt into 4 ohms
"A" Weighted Signal to Noise Ratio
Referenced to rated output into 4 ohms
Crossover Slope
Crossover Frequency
Frequency Response
Signal Voltage Adjustment Range
Remote Punch Level Control (replacement kit)
Protection
Punch Bass
Input Impedance
Operating Voltage
Balanced Inputs
CMRR (Common Mode Rejection Ratio)
Damping Factor
THD+N (Total Harmonic Distortion + Noise)
* These specifications are CEA-2006 Compliant
10
Specifications subject to change without notice
R500-1
320 Watts x 1
500 Watts x 1
2.40" (6.10cm)
7.67" (19.49cm)
16.65" (42.30cm)
(2) 30A ATC
60A
≥85 dB
≥105 dB
12dB/octave Butterworth
Low Pass variable from 40Hz to 130Hz
20Hz to 250Hz ±1dB
Variable from 150mV to 8V (RCA Input)
#PLC
Short circuit protection shut downs the amplifier in
case of very low impedance or shorted speaker wires.
Variable from 0dB to +12dB @ 45Hz
20K ohms
9 to 16 Volts DC
No
>55dB @ 1KHz
>200
< 1.0% @ 4 ohm