Specifications - Rockford Fosgate PUNCH P200.2 Installation Und Betriebsanleitung

S
PECIFICATIONS
MODEL- PUNCH
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4 Load Per Channel
2 Load Per Channel
4 Load Bridged (Mono)
Dimensions:
Height
Width
Length
Amplifier Fuse Rating (Amp/Type)
Battery Fuse Rating (Amp) External
(Not Supplied)
Signal-to-Noise Ratio
Crossover Slope
Crossover Frequency
Frequency Response
Bandwidth
Slew Rate
IM Distortion (IHF)
Signal Voltage Adjustment Range
Protection
Equalization (45Hz Punch Bass) (All models except P200.2)
Input Impedance
These specifications are Amplifier Power Standard CEA-2006 Compliant
Specifications subject to change without notice
12
P550.2
150 Watts x 2 175 Watts x 2
275 Watts x 2 325 Watts x 2
550 Watts x 1 650 Watts x 1
2.1" (5.33cm) 2.1" (5.33cm)
11" (27.94cm) 11" (27.94cm)
13.7" (34.80cm) 16.4 (41.66cm)
(2) 30A / ATC (2) 40A / ATC
60A
NOMAD - Internal analog-computer output protection
P650.2 P850.2
225 Watts x 2
425 Watts x 2
850 Watts x 1
2.1" (5.33cm)
11" (27.94cm)
17.7" (44.96cm)
(3) 40A / ATC
80A 120A
>80dB A-weighted @ 2Vrms
12dB/octave Butterworth
variable from 40Hz to 400Hz
20Hz to 20kHz ±0.5dB
20Hz to 200kHz ±3dB
30 Volts/µS
<0.05%
Variable from 150mV to 4V (RCA Input)
circuitry limits power in case of overload, plus short
protection.Thermal switch shuts down the amplifier
in case of overheating.
Variable from 0dB to +18dB @ 45Hz
10k ohms
P1200.2
300 Watts x 2
600 Watts x 2
1200 Watts x 1
2.1" (5.33cm)
11" (27.94cm)
17.7" (44.96cm)
(4) 40A / ATC
160A