Specifications - Rockford Fosgate Prime R1000-1 d Einbau Und Betrieb

S
PECIFICATIONS
MODEL- PRIME
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts*
4 Load Mono
2 Load Mono
Dimensions:
Amplifier Fuse Rating (Amp)
Battery Fuse Rating (Amp) External (Not Supplied)
"A" Weighted Signal to Noise Ratio (CEA-2006)
Referenced to 1 Watt into 4 ohms
"A" Weighted Signal to Noise Ratio
Referenced to rated power into 4 ohms
Crossover Slope
Crossover Frequency
Frequency Response
Signal Voltage Adjustment Range
Remote Punch Level Control (replacement kit)
Protection
Punch Bass
Input Impedance
Operating Voltage
Balanced Inputs
Damping Factor
THD+N (Total Harmonic Distortion + Noise)
* These specifications are CEA-2006 Compliant
10
150 Watts x 1
250 Watts x 1
Height 2.40" (6.10cm)
Width 7.67" (19.49cm)
Length 11.54" (29.30cm)
Specifications subject to change without notice
R250-1 R500-1
320 Watts x 1
500 Watts x 1
2.40" (6.10cm)
7.67" (19.49cm)
16.65" (42.30cm)
(1) 30A ATC (2) 30A ATC
40A 60A
≥80 dB
≥100 dB
12dB/octave Butterworth
Low Pass variable from 40Hz to 130Hz
20Hz to 130Hz ±1dB
Variable from 150mV to 8V (RCA Input)
#PLC
Short circuit protection shut downs the amplifier in
case of very low impedance or shorted speaker wires.
Variable from 0dB to +12dB @ 45Hz
20K ohms
9 to 16 Volts DC
No
>200
< 1.0% @ 4 ohm
R1000-1d
500 Watts x 1
1000 Watts x 1
2.40" (6.10cm)
7.67" (19.49cm)
11.54" (29.30cm)
(3) 30A ATC
90A